Telular’s TG-1 Express is now offered in a CDMA Version!

TG-1 Express for Verizon CDMA Towers

TG-1 Express for Verizon CDMA Towers


Telguard, a leader in wireless alarm communications, interactive and home automation services now offers a TG-1 Express CDMA cellular alarm communicator on the Verizon Wireless network. The CDMA TG-1 Express is an ideal primary residential solution for areas where cellular coverage may be challenging. Based on the same proven, flexible features and functionality of the TG-1 Express for 3G/4G networks, the CDMA version helps reduce cost and Installation time in just about every application.

The UL listed TG-1 Express CDMA uses the power and backup battery of the security panel eliminating the need for an available wall outlet. The unit also features a unique way to connect to the panel for instances when the communicator needs to be installed remotely. The Single Line Interface Cable (SLIC) allows the power and telephony connection to be sent over a single CAT5 cable, similar to how computer networks use Power over Ethernet (PoE). With the SLIC option installers can now remotely mount the TG-1 Express CDMA without being limited by the availability of power or the expense of an RF cable run.

“Telguard’s TG-1 Express for 3G/4G networks has been a go to universal communicator in our residential portfolio because of its ideal price point, quality and overall reliability,” said Mike Putman, Director of Operations, Ackerman Security. ”Recently, we’ve had the opportunity to install the new TG-1 Express CDMA in both areas where we could never get coverage in the past, as well as in major metropolitan areas. The TG-1 Express CDMA has proven itself to work as flawlessly as its 3G/4G counterpart in every scenario.”


Facebooktwittergoogle_plusredditpinterestlinkedinmail

 How to Wire a TG-1 Express 3G/4G Universal Alarm Communicator?


  • Push the two indentations on the bottom of the communicator with a tiny flat head screwdriver.
  • Once communicator face plate is lifted off look on the bottom left of the communicator you should see 5 pins sticking up.
  • Locate the blue bus that comes in the plastic rappers out of the box
  • Looking at the front of the bus all the way to the right is your power “red” and to the immediate left of the power will be the area for the ground “black” to be wired.
  • Run the wires through the back of the communicator and wire the power into its designated slot as well as the ground.
  • Slide the bus onto the 5 pins again making sure the power is all the way to the right and the ground right next to it on the left.
  • Run the phone cable through the back as well and make sure it slides into its designated area until it clicks
  • Screw in the antenna and you all set!
Facebooktwittergoogle_plusredditpinterestlinkedinmail